The cup was designed to be placed in the angled tube on the side of the cockpit like the one in the photos. It is very resistant and wide for all types of drinks and cups
Printed with PLA at .2mm, it does not require supports and it is recommended to use between 35 to 50% infill and a good adhesion of the bed.
Two long straps are passed through the two inclined holes to hold it to the cockpit. I recommend putting some rubber bands between the tube and the holder so as not to damage the paint on the cockpit.
| Cockpit_Angular_Drink_Holder_eigk3d.stl | 25.9MB |
