Coax Crossover Case 3D Printer Model
The file 'Coax Crossover Case 3D Printer Model' is (stl) file type, size is 1.8MB.
The file 'Coax Crossover Case 3D Printer Model' is (stl) file type, size is 1.8MB.
This is for implementing a screw-on crossover on back of the La Dolce Audio 15' open baffle mid-range driver. This screws into the back of the driver where the 1' compression tweeter would normally go. This is for users who have moved the tweeter to a separate horn. This closes off the hole and can be used with any of the LDA 15' Phase Plug designs below:
This crossover was designed for the following crossover parts:
The design uses 6mm Hex Screws to attach all the components. You can buy those here:
With the LPAD attenuator in the case, I use the following screw cap on the outside to replace the cheap plastic one that comes with it:
If you don't have a 3D printer, you can get any of these components printed by a 3rd party like Craft Cloud.
| CrossOver_Case_-_Base.stl | 629.1KB | |
| CrossOver_Case_-_Base_Screw.stl | 534.8KB | |
| CrossOver_Case_-_Top.stl | 3.2MB |
