Wall Mounted Coaster. 104mm tall by 104mm long and 101mm wide with a 99mm opening with sloping sides to hold your beverage in place nicely.

The inspiration was drawn from the fact my work bench made of 2X4's as well as my desk which is in a corner generally leads to me wanting a coffee but having my coffee on my workspace is more catastrophic and or dangerous than it should be.

To relieve this problem I created this wall mounted mug holder, or drink coaster to hold my drink in a nice safe place.

I haven't made or tested one yet, so this will be listed as a work in progress until I can fully test it. Print and test at your own risk. I am new to using CAD, so this may look rudimentary and or basic, so bare with me as I try to clean it up a bit more, feel free to tweak and make it your own as well.

Update: 1/14/2017

I have finally printed out one of these and tested it, there are some tweaks and changes I'm going to have to make to better improve the design, or suggest using smaller screws to mount. I may have used construction grade screws and was hoping to use such and ended up with somewhat of a split in an area where the print and the drill holes meet. That said the Print was in fact successful and is, in my opinion, functional for average sized coffee mugs as the lip actually holds a coffee mug in place Expect a Version 2.0 in the near future, but I'm not sure if I personally will be making one as I'm happy with this one.