CMW Massive Droner HD TPU Kit 3D Printer Model
The file 'CMW Massive Droner HD TPU Kit 3D Printer Model' is (stl) file type, size is 4.7MB.
The file 'CMW Massive Droner HD TPU Kit 3D Printer Model' is (stl) file type, size is 4.7MB.
This is a lightweight TPU set for the CMW Massive Droner HD frame.
Includes arm bumper, Caddx Peanut mount, battery pad, frame brace, antenna mount, and camera protector, with variations.
All parts are designed to be printed out of TPU 95A.
Printing instructions / suggestions:
The Peanut mount slips onto the black knurled standoff above the FPV camera. The mount is designed to press firmly, but flexibly against the Vista, holding the Peanut in place, and also providing some resonance dampening.
The "Front frame brace" reinforces the joint between the front arm brace and the side plates.
The "Front frame brace long" comes with a bit of extra room for wires. The photos show the normal one.
The angle of the Peanut is relative to the bottom plate.
Needed to complete:
| Battery_pad_hollow_TPU.stl | 273.7KB | |
| Battery_pad_solid_TPU.stl | 184.3KB | |
| Bumper_front_left_TPU.stl | 651.6KB | |
| Caddx_Peanut_mount_15deg_TPU.stl | 1.5MB | |
| Caddx_Peanut_mount_20deg_TPU.stl | 1.5MB | |
| Caddx_Peanut_mount_25deg_TPU.stl | 1.5MB | |
| Caddx_Peanut_mount_30deg_TPU.stl | 1.4MB | |
| Caddx_Peanut_mount_35deg_TPU.stl | 1.4MB | |
| Camera_protector_TPU.stl | 565.6KB | |
| Front_frame_brace_long_TPU.stl | 205.3KB | |
| Front_frame_brace_TPU.stl | 211.8KB | |
| TrueRC_Singularity_+_Minimortal_mount_TPU.stl | 1.7MB | |
| TrueRC_Singularity_mount_TPU.stl | 1.6MB |
