Cloud Toilet Paper Holder 3D Printer Model
The file 'Cloud Toilet Paper Holder 3D Printer Model' is (stl) file type, size is 162.5KB.
The file 'Cloud Toilet Paper Holder 3D Printer Model' is (stl) file type, size is 162.5KB.
This is a toilet paper holder with a shape inspired by a cloud.
For space reasons it isn't so big, so it can accomodate only 4 full size rolls and one more reduced size roll.
Due to my 3d printer build plate, I divided the box into three parts.
I printed the box using a build plate of 210 x 210 mm (Flying Bear Ghost 5). For the height 10 cm is enough.
If you prefer to see the paper roll on the top-right side more in center, it is possible to integrate the holder with a support.
The support will hold the top roll about 1 cm above the 3 baseline rolls.
The 3 parts have 2 joints on each side so they can stick together.
To hang it on the wall I used 3 hooks for countersunk screws.
I added the possibility to close the toilet roll hole with a cap. Then you can decorate the cap, for example with a drop.
The cap can be fixed in the hole using 5 curved strips. Each strip has a L-shaped attachment for the corresponding hole in the cap.
The strips are of two shape: a shape for small toilet rolls and a shape for larger toilet rolls.
Strips with narrow curvature have a diameters of max 40 mm.
Strips with wider curvature have a diameters of max 47 mm.
Then I created drops of 3 sizes.
Drops can be glued to the cap.
| Extra_part_support.stl | 8.7KB | |
| large_drop.stl | 78.1KB | |
| medium_drop.stl | 78.1KB | |
| narrow_radius_strip.stl | 12.7KB | |
| Part_1_left.stl | 34.5KB | |
| Part_2_top.stl | 38.6KB | |
| Part_3_right.stl | 35.7KB | |
| Part_3_right_with_insert_for_support.stl | 36.7KB | |
| roll_cap.stl | 83.9KB | |
| small_drop.stl | 78.1KB | |
| wide_radius_strip.stl | 12.7KB |
