The file 'Clip For Holding 0.08in/2mm Plexi To The Frame Of The Prusa Ikea Lack 3D Printer Enclosure 3D Printer Model' is (stl) file type, size is 5.0KB.
Just a simple little clip for holding 2mm / 0.08in plexi to the frame of a Prusa Lack Enclosure, to stop it flexing so much (especially if extended vertically.
Just rotate to print the with the base horizontal, and supports are not needed
I used #10-3/4" wood screws for securing to the legs and underside of the Lack table.
(any similar sized metric wood screws should suffice)
Use with these modified corner pieces for the Prusa Lack Enclosure which have been modified for 2mm / 0.08in plexiglass / clear acrylic sheet
https://www.thingiverse.com/thing:2974706
| Lack_enclosure_2mm_Plexi_holder_v1.stl | 22.2KB |
