I purchased a cheap solution to vacuum pack my filaments.
Most solutions available on Amazon are variations of the same thing:
A cylinder with some gasket or fitting on on end and a cord on the other.
It works pretty well but takes up space and kicks around on my desktop.
No way I was going to unplug and stow it in the provided pure silk bag with actual gold trim, platinum accents and angora lining.
After much searching, my lazy bones could not locate a solution.
Mother invented necessity.
I bumped the thing hard and broke it.
Beefed it up, reduced the inner circumference a tad to make easier operation with thicker sides.
Now wish I had found the screws rather than just reaching for the glue bottle.
| cheap_vacuum_sealer_bracket-V2.0.stl | 716.7KB | |
| cheap_vacuum_sealer_bracket.stl | 291.8KB |
