Clamp Mounted PS5 Controller Stand (with Clearance For Headphone Jack) 3D Printer Model
The file 'Clamp Mounted PS5 Controller Stand (with Clearance For Headphone Jack) 3D Printer Model' is (stl) file type, size is 1.1MB.
The file 'Clamp Mounted PS5 Controller Stand (with Clearance For Headphone Jack) 3D Printer Model' is (stl) file type, size is 1.1MB.
I needed a stand for my PS5 controller that would mount to my wheel stand and accommodate the headphone jack at the bottom of the controller.
This probably fits other controllers, but was designed specifically for the PS5 DualSense, so YMMV if using it for anything else.
Prints without supports.
Note I needed to reprint the thumb screw and adjust horizontal expansion in Cura (+0.1) otherwise it was a little loose. This will depend on your printer setup, so you may have to experiment, but the thumb screw is pretty quick to reprint if you need to.
| PS5_controller_clamp_body.stl | 727.6KB | |
| Thumb_Screw.stl | 1.6MB |
