Use for Cisco device with overly-aggressive SIMM socket that bends PVDM2 modules until they break and die. Height was intended for 881-V but probably works on 28xx heights at a guess.
Print in 100% or close to infill. If not, use something with good diagonal infill structures else it bends too. Friction fit to the pcb. May require some filing at the ends where tolerances are too tight to fit card in. Glue optional but T7000 is good stuff.
Untested in actual service. Probably PVDM2 will become warm and cause PLA to bend... a milled heatsink probably is better. one day...
| pvdm2brace.skp | 1.2MB | |
| pvdm2brace.stl | 6.9KB |
