Circular container on a swivel with magnetic latch. 8 cm dia. 3 different heights 15mm, 20mm and 30mm. Each height is divided up to 4 sections.
Materials used:
3mm rod
4mm x 2mm disc magnets
Only difference with Bottom part is the hole for magnet is only on top and the hole for the rod has a tighter tolerance and doesn't go all the way through.
Before putting the magnets in make sure all polarities face the same direction. Randomly putting them in like I did does not turn out well unless you're lucky
| bottom_15mm_1_section.stl | 312.5KB | |
| bottom_15mm_2_sections.stl | 312.6KB | |
| bottom_15mm_3_sections.stl | 312.6KB | |
| bottom_15mm_4_sections.stl | 312.6KB | |
| bottom_20mm_1_section.stl | 312.5KB | |
| bottom_20mm_2_sections.stl | 312.7KB | |
| bottom_20mm_3_sections.stl | 312.7KB | |
| bottom_20mm_4_sections.stl | 312.7KB | |
| bottom_30mm_1_section.stl | 312.5KB | |
| bottom_30mm_2_sections.stl | 312.6KB | |
| bottom_30mm_3_sections.stl | 312.6KB | |
| bottom_30mm_4_sections.stl | 312.6KB | |
| Cover.stl | 9.9MB | |
| middle_15mm_1_section.stl | 383.0KB | |
| middle_15mm_2_sections.stl | 382.9KB | |
| middle_15mm_3_sections.stl | 234.5KB | |
| middle_15mm_4_sections.stl | 234.0KB | |
| middle_20mm_1_section.stl | 383.0KB | |
| middle_20mm_2_sections.stl | 382.9KB | |
| middle_20mm_3_sections.stl | 383.0KB | |
| middle_20mm_4_sections.stl | 383.1KB | |
| middle_30mm_1_section.stl | 383.0KB | |
| middle_30mm_2_sections.stl | 382.9KB | |
| middle_30mm_3_sections.stl | 382.9KB | |
| middle_30mm_4_sections.stl | 382.9KB |
