Cigarette Case 3D Printer Model
The file 'Cigarette Case 3D Printer Model' is (stl) file type, size is 472.7KB.
The file 'Cigarette Case 3D Printer Model' is (stl) file type, size is 472.7KB.
Watertight container with a twist cap. You need a 15mm x 2mm O-ring between the cap and bottom to make it properly watertight/mostly airtight, although you can use it perfectly fine without an O-ring.
Fits fine if you use 8mm filters when rolling. The width inside is 11mm and length 90mm.
I suggest printing both pieces upright with the solid ends facing down, wont need any supports. Adding a few wall layers will ensure waterproofing. If you make sure the Z seam is in the same spot for both pieces, it will help aligning the cap while closing the case.
| HolderBottom.stl | 685.9KB | |
| HolderTop.stl | 1.1MB |
