Bulbasaur is ready for Christmas! The tree has a space for a tealight in it. There are two versions of the tree, with and without holes for light to shine through. Both trees are provided without supports, or with sacrificial layer supports.
Print at 110% to allow space for a LED tealight inside.
The Stump/Trunk should be printed with the top surface on the print bed to print without supports. Use the version with the spike to hold it to the bulbasaur body better, or the version without as a stand-alone tree.
Recommended to only use LED flickering tealights- I would never recommend using actual candles with any 3D printed design!
This Bulbasaur body has a much lower polygon count then the one for the pumpkin bulbasaur, but is compatible with the pumpkin.
| Bulbasaur_Body_hole.stl | 13.6MB | |
| Lights_Tree-No_Supports.stl | 624.4KB | |
| Lights_Tree.stl | 726.9KB | |
| Solid_Tree-No_Supports.stl | 261.8KB | |
| Solid_Tree.stl | 385.7KB | |
| Star.stl | 44.1KB | |
| Stump-with-spike.stl | 3.7MB | |
| Stump.stl | 143.5KB |
