Multiple baubles to christmas tree (35 variants and sizes).
Prepared for printing in vase/spiral mode - I recommended minimal 0,4 or 0,5 nozzle and set extrusion line width more than 100%. In some parts of baubles (overhangs) i use layer height 0,1 or 0,15, othervise 0,2 mm.
Must be printed upside down and you must add larger brim/skirt (8-10mm width).
Very good looking from transparent ABS (clear and red on images), transparent PLA is usable too (green on images). PETG I not tested.
Top handle i printed from gold/silver PLA. All inserted baubles using identical size of handle.
If you will change X/Y size of any bauble, you must print handle in identical size.
EDIT: some original files had bad size of bottom cylinder - I repaired it and upload new versions (with _fixed in name)
| cone-120b_fixed.stl |
| cone-120d_fixed.stl |
| cone-120l.stl |
| cone-120x.stl |
| cone-120y_fixed.stl |
| cone-140b_fixed.stl |
| cone-140d_fixed.stl |
| cone-140l_fixed.stl |
| cone-140x_fixed.stl |
| cone-140y_fixed.stl |
| egg-080b.stl |
| egg-080d.stl |
| egg-080l.stl |
| egg-080x.stl |
| egg-080y.stl |
| egg-110b_fixed.stl |
| egg-110d.stl |
| egg-110l.stl |
| egg-110x.stl |
| egg-110y.stl |
| handle.stl |
| hedgehog-100.stl |
| icicle-h100l.stl |
| icicle-h100x.stl |
| icicle-h150l.stl |
| icicle-h150x.stl |
| icicle-m100x.stl |
| icicle-n100l.stl |
| icicle-n100x.stl |
| icicle-n150l.stl |
| icicle-n150x.stl |
| needle-140b_fixed.stl |
| needle-140d.stl |
| needle-140l.stl |
| needle-140x_fixed.stl |
| needle-140y.stl |
