When printing the bell it is necessary to change the filament twice according to your needs of color composition. I used the exchange at the height of 5 mm and 40 mm.
Support is not needed.
What is the trick on this printing is setting the Pusaslicer. I used the instructions from Průša:
https://www.youtube.com/watch?v=6PVeh43Or-g
As an infill I used 20% Gyroid.
| Válec_víčko_s_držákem.stl | 214.6KB | |
| Vánoce_zvon_tělo.stl | 2.2MB |
