this phone stand installs in the upper cubby on first gen avalanches ( right under the HVAC controls )This should also fit similar years of Tahoe and Suburban. Pull out the factory rubber mat, and sit this tray in place. You'll need 2 of the pins as well, it locks the plate in place using the factory holes that are in the bottom of the cubby.
I designed this but did not print it myself. I know the one I have is PETG and holds up very well to summer heat, it has not deformed at all. The early iterations were printed with PLA, and I actually prefer the pins that were made from PLA, as they had a little more "give" as you install them.
| avalanche_phone_holder.STL | 41.6KB | |
| avalanche_phone_holder_pin.STL | 113.5KB |
