Cherry Blossom – Easy Stamen 3D Printer Model
The file 'Cherry Blossom – Easy Stamen 3D Printer Model' is (stl) file type, size is 140.6KB.
The file 'Cherry Blossom – Easy Stamen 3D Printer Model' is (stl) file type, size is 140.6KB.
INFO
This is a remix of Kijai's cherry blossom. We all know the stamen is impossible to print, so I solved this by disassembling the center stamen piece and included the sticks separately. Simply print the center stamen piece 3 times with supports and 100% infill. Print the sticks with a brim at @ 100% infill; carefully peel apart 10 sticks per cherry blossom (two per pedal).
ASSEMBLE
As shown in the photo, put a slight bend at each of the sticks to where they are pointing down in the center well of the flower. Tape two sticks to each pedal for a total of 10. Drop super glue in the center well.
As shown in the photo, put the center stamen piece in the middle on top of the sticks and put super glue all around. Let dry overnight then remove the tape.
ADJUST & PAINT
As shown in the photo. lift and adjust the sticks randomly. Boil some water and dip the sticks in and adjust per need. Trim the sticks down and paint the tips yellow. Enjoy!
| Stamen_Remix_Center.stl | 291.3KB | |
| Stamen_Sticks.stl | 10.2KB |
