Quick stand I designed to hold my LiPo charger at 45 degrees to make it easier to use.
Two versions of the cross brace are included, one with 0.15mm clearance and one with 0.30mm clearance. For a well calibrated printer the 0.15mm version should be sufficient. If it is a little loose a drop of hot glue will hold it together.
I have included a dimensioned drawing of the stand so you can check its the right size for your charger.
| Charger_Stand_Brace_0.15_gap.stl | 3.2KB | |
| Charger_Stand_Brace_0.30_gap.stl | 3.2KB | |
| Charger_Stand_Drawing.pdf | 179.9KB | |
| Charger_Stand_Side_Support.stl | 7.1KB |
