The idea for this project was to be used as a pump for cooling liquid on a lathe.
Using ideas from other similar designs, i created a new more efficient water pump.
All printed and tested in PLA with a printed rubber seal.
motor i designed this around was 28mm in diameter and the shaft was 2.2mm.
the water is output through a 5mm hose adapter (fish tank bubble tube).
I was able to tap the 4mm holes so i could screw straight into the plastic with M4 bolts
| Impeller.stl | 471.7KB | |
| Pump_Housing.stl | 518.1KB | |
| Pump_Motor_Holder.stl | 197.0KB | |
| Rubber_Seal.stl | 109.8KB |
