Centrifugal Compressor With Bearing Support And Screw Holes 3D Printer Model
The file 'Centrifugal Compressor With Bearing Support And Screw Holes 3D Printer Model' is (stl) file type, size is 5.7MB.
The file 'Centrifugal Compressor With Bearing Support And Screw Holes 3D Printer Model' is (stl) file type, size is 5.7MB.
Centrifugal Compressor with support for a bearing to reduce noise and increase stability at high rpm's.
Also it comes with holes to avoid the use of glue so its easier to unmount/mount. It is still possible to mount it without screws, just use some tipe of plastic glue to hold it together.
Needed:
-608 Bearing. (AKA skateboard bearing)
-10 2.9mm Screws (This may vay depending on the model size)
-All of above are recommended but not compulsory. The design will still work with out the bearing and the screws(in this case you nees to glue it toghether.-
| BEARING-IMPELLER_SHAFT.stl | 7.5KB | |
| HAT.stl | 16.1MB | |
| HAT_V2.stl | 529.5KB | |
| IMPELLER.stl | 28.2MB | |
| MOTOR_HOLDER_V2.stl | 108.4KB | |
| SK1_V2.stl | 438.0KB | |
| SK2_V2.stl | 501.4KB |
