Centaur For Warhammer Quest 3D Printer Model
The file 'Centaur For Warhammer Quest 3D Printer Model' is (stl) file type, size is 901.2KB.
The file 'Centaur For Warhammer Quest 3D Printer Model' is (stl) file type, size is 901.2KB.
It took forever to find the right pieces for this one! Most horse bodies have legs that are too thin to print well are snap off too easily. Finally found @Tonoborus 's centaur, but needed a torso holding a bow instead of the spear. Enter the archer by @Dirsh.
Printing this was still difficult, again because of the legs, so I printed the thing upside down, and slanted at 45 degrees so that I didn't have to try to pull any supports away from the legs. A raft and supports were needed as well.
I ended up using the 25 mm flagstone bases base made by @Dutchmogul and glued them on afterwards. Worked great!
All the level one Warhammer Quest monsters can be found here:
https://www.thingiverse.com/thing:3469828
The main jumping off page for my Warhammer Quest project is here:
https://www.thingiverse.com/thing:3469741
| Centaur-2018-09.stl | 1.9MB |
