Thank you to FP-Creator for the nice ring.

I used it to make this celtic storage cylinders/boxes. There are six different sizes and additional three sizes stackable.

There is a simple lid too.

The cylinder may usable as nice planter too.

A version without the inner wall (but not as strong as this one) can found here: https://www.thingiverse.com/thing:3328763 All versions have the same size. If you scale it by the same factor you can mix it, particular the stackable ones.

I guess the cylinders are printable without support. (but not sure and depends on the scaling) The lid and the stackable versions will need support (at the bottom).

(The first image is only as summary and not for printing.)

If you want to create your own lid (at the current scale) create a cylinder 88x5mm (for the hole which is 89 diameter) and a cylinder 94-96mm diameter for the top of the lid.

Update: I add the size 1-3 in a stackable version.

Update: There is a cat lid too: https://www.thingiverse.com/thing:3334035

Update: I made it, see https://www.thingiverse.com/make:590402 I scaled it to 120% and cylinder and lid fits perfect, so I am not sure on 100% scale it fits perfect too. In 100% there is a 0.5mm gap between, each side. This means the stackable too. Maybe print a test first or be prepared to sand the lid a bit.