Cell Housing For LED Strip To Ride Skateboard In Night (DIY) 3D Printer Model
The file 'Cell Housing For LED Strip To Ride Skateboard In Night (DIY) 3D Printer Model' is (STL) file type, size is 6.7KB.
The file 'Cell Housing For LED Strip To Ride Skateboard In Night (DIY) 3D Printer Model' is (STL) file type, size is 6.7KB.
Before you daily drive with this attached, make sure to do a ground clearance check to see if the anything is getting bumping into ground. Keep in mind you are dealing with batteries.
It can hold 4x 18650 cells but for my use 2 were suffice since the led I used was rated for 12v and 0,8A. Barrel plug connected was from a cheap power adapter I got from electronic shop.
LED strip was from amazon and is waterproof. Cell housing and led strip is stuck to deck with cyanoacrylate.
You might have to use "clip" I added as well if you feel the fittings are tight and the cell housing is slipping off.
| skateboard_cell_housing_clip_0.25_tolerance.STL | 1.6KB | |
| Skateboard_led_strip_cell_housing_fixture_tolerance_fixed.STL | 2.8KB | |
| Skateboard_led_strip_cell_housing_fixture_v2.STL | 12.8KB | |
| Skateboard_led_strip_cell_housing_v1.STL | 4.6KB | |
| Skateboard_led_strip_cell_housing_v3.STL | 11.0KB |
