This is a remix of the "2-Lead_Screw_Bracket.stl" in the D-bot by by spauda01.
This model fits the anti backlash nut from openbuild. Its important to mount the nut the correct way. As in picture.
Turn model 90 degrees before print. No support needed.
<<-- TIP DESIGNER
If you get the problem with the motor mount not fitting when using my design, use this: https://www.thingiverse.com/thing:2474608/#comments
(PS: 16.02.17: I updated the model since I found a little error in the design. The hole for the nut was 0.7mm too far from the rail. A nema 17 motor is 42 mm wide, so the correct distance from center of nut to rails are 21mm not 21.7 mm. Now fixed. Im using the old design without problems, so no need to freak out if you already printed one)
| zaxis_lead_screw_anti_backlash_v5.stl | 398.1KB |
