Caulking/Silicone Tube Applicator – VASE-MODE (Refresh Your Hole!) 3D Printer Model
The file 'Caulking/Silicone Tube Applicator – VASE-MODE (Refresh Your Hole!) 3D Printer Model' is (stl) file type, size is 22.3KB.
The file 'Caulking/Silicone Tube Applicator – VASE-MODE (Refresh Your Hole!) 3D Printer Model' is (stl) file type, size is 22.3KB.
Ever go to reuse a tube of caulk / silicone & have to cut the tip back a bit to pry out the cured bit before you can use the remaining bit in the tube?
Well, I have! All the time! - Recently needed to be able to get a fine point when fixing my sink & almost went to buy a whole new tube of caulking when I remembered... I have blender & a 3D printer!!!
Printed in Vase Mode w/ TPU, this was especially helpful as I was able to actually squeeze the end to get it right into the fine space & shape that I needed for a clean application of my silicone. The TPU meant i was also able to apply it at a slight angle, which was helpful since my caulking gun wouldn't fit in the sink!
The base is about 15mm, which will allow it to fit snuggly even if you've snipped the tip further than a mohel w/ bad eye sight!
| Silicone_applicator.stl | 37.6KB | |
| Silicone_applicator_FinerPoint.stl | 40.7KB |
