The Colonies edited to fit and covers
https://www.thingiverse.com/thing:4693005
Explorer and Pirates Expac covers
https://www.thingiverse.com/thing:4690042
traders and barbarian tiles for these interlocking bases
https://www.thingiverse.com/thing:4679487
Seafarer Expansion covers
https://www.thingiverse.com/thing:4670578
https://www.thingiverse.com/thing:4663644
santa cover
https://www.thingiverse.com/thing:4653618
updated the handle because it was too short. oops!
edit again
added the bolts as a separate file for people having issues printing them alone. I suggest adding a raft.
EDIT
I modified this tower so the pieces fit better, no sanding needed. I also chopped it up so it's multiple pieces. :)
I built a 3d catan board
https://www.thingiverse.com/thing:2525047
but i didn't want to spend so much money on the magnets, so i used bases found here
https://www.thingiverse.com/thing:3700300
However, very early into the process i realized i had no way to easily store them and found no options for these types of bases. So, using 3d builder, i created this tower for holding my pieces.
This version is very snug, so I had to sand it down a bit to get it all to fit. I'm working on a new version that will make the sanding unnecessary, but it's still a WIP.
I wanted a carry handle, but also wanted to use the center hole to hold a tower for my different robbers (it also fits the tube for catan numbers found here https://www.thingiverse.com/thing:2927739 which holds these numbers https://www.thingiverse.com/thing:2884108 or the basic cardboard ones)
Handle design is from here https://www.thingiverse.com/thing:3628427
Handle is included with locking sides added. (print at 40% infill) I used https://www.thingiverse.com/thing:2486040 this latching system to snap the handle on. it is included separately and would need to be printed at 90% infill to be strong enough to hold it. I super glued it on the sides since it has to be printed in pieces to work. (and some might not want it at all)
I also found that the pieces would hit the tops of the pieces and possibly damage them so i used these https://www.thingiverse.com/thing:2837866 storage covers, cut a spot out the puzzle piece so they could slide onto the tower easily and hold in place. (also included)
| brick_cover.stl | 268.2KB | |
| center_robbers.stl | 4.1MB | |
| Desert_cover.stl | 342.4KB | |
| harbor_cover.stl | 768.3KB | |
| locking_bolts_only.stl | 186.0KB | |
| ore_cover.stl | 1.1MB | |
| Tile_holder_v2_main.stl | 16.0MB | |
| Tile_Holder_v2_part_2.stl | 15.8MB | |
| Tower_Handle_v2.stl | 793.1KB | |
| wheat_cover.stl | 549.6KB | |
| Wood_Cover.stl | 452.2KB | |
| Wool_Cover.stl | 432.4KB |
