Catacombs And Castles Fast Setup Walls 3D Printer Model
The file 'Catacombs And Castles Fast Setup Walls 3D Printer Model' is (STL) file type, size is 6.5MB.
The file 'Catacombs And Castles Fast Setup Walls 3D Printer Model' is (STL) file type, size is 6.5MB.
Fast set up walls for Catacombs and Castles. Originally designed to fit in the C&C 2e box.
Watch it get set up in about 30 seconds here:
https://youtu.be/j8nfgzHe4QQ?si=wJkZnkAixW_LBFCX
The design is meant to be able to use simple supplies like a paperclip as a joint. There are slight recesses for the ends of the paperclip so there are no tables getting scratched.
I printed these on end with brim tabs and support only for the hinges.
There is also some clips. I've styled them like old torch sconces. You can print flames if you want to add a little bit of character to your clips. If you want additional straightness, I've included clips that sit across the joints to help keep them at 180 degrees.
To replace the 12 walls from the original set, you will need to prints 8 outer walls and 4 inner walls. And at least 4 wall clips.
| clip-joint-noflame.STL | 741.5KB | |
| clip-joint-V2.STL | 742.1KB | |
| clip-wall-noflame.STL | 617.1KB | |
| clip-wall-v2.STL | 632.1KB | |
| flame-joint.STL | 736.2KB | |
| flame-wall.STL | 736.8KB | |
| inner-wall.STL | 10.5MB | |
| outer-wall.STL | 10.6MB |
