Little cat to hold a phone or tablet while charging. Cute for Halloween when printed in black. I printed it laying on its side with supports for the cord holes.
Update 8/22/20
I have cleaned up the file the new one is phonecat3.5.stl and should not have the layer problems that the old file had. Other than that the design is the same.
I have newer software and a newer 3D printer now and can definitely print this without supports when printed laying flat on it's side.
I have also redesigned the entire stand now that I have more experience and will post it as a separate thing. The new one I think is a much better design, but it is larger and takes 14 hours to print. This one only takes 5 hours, so there is a trade off.
new version https://www.thingiverse.com/thing:4576645
| Phonecat3.5.stl | 4.5MB | |
| Phonecat3.stl | 7.9MB |
