Cat scratch brush for corners. Fill it with catnip.
Brush parts (odd and even) are printed in TPU
Frame and lid in PLA.
A couple of different frames to choose from. 50-150mm (height of brush part)
The brush parts are 5mm high each.
There are even and odd brush sets with different brush pin positions.
Ex for 50mm cat scratcher
1x 50mm frame
1x Lid
5x Tpu_Odd
5x Tpu_Even
Lid is screwed in place with 3mm screws 10-16mm length.
Fasten with double sided sticky tape or screws.
There are also a distance piece if you want to add your own brushes or have bigger gap between brush sets.
Edit: Updated some of the frames where the bottom catnipholes where just a big hole..
Edit2: added v2 of tpu_odd some hade problems slicing v1. thanks Aaronkellum
Edit3: went back to base models of tpu parts and fixed them up. so they should be without small errors. Print and enjoy!
| corner_distance.STL | 114.7KB | |
| corner_frame100mm.STL | 240.8KB | |
| corner_frame150mm.STL | 241.2KB | |
| corner_frame50mm.STL | 240.5KB | |
| corner_frame75mm.STL | 240.7KB | |
| corner_lid.STL | 193.2KB | |
| tpu_even_v3.STL | 953.5KB | |
| tpu_odd_v3.STL | 953.3KB |
