The file 'Cat Air Conditioner 3D Printer Model' is (stl) file type, size is 286.9KB.
=^.^= THE PUSAIRCON =^.^=
This is a swamp air-conditioner unit that you can attach to your cat's carrier to help cool them during their journey!
BILL OF MATERIAL
1x 120mm 12v computer fan
Amazon: https://www.amazon.com/gp/product/B07HK9XJH5
1x rocker switch
Amazon: https://www.amazon.com/gp/product/B0725Z6FR7
1x 9v battery clip
https://www.amazon.com/dp/B08SL9X2YC
1x Miniature baggie 3" x 5" (freeze with water)
https://www.amazon.com/Reclosable-Plastic-Resealable-Sealing-Storage/dp/B08JGS8PN
2x 12cm rubber bands or elastic string
For securing the baggie up top
6x wires or zipties
To secure the unit to your cat carrier and the lid
Project wire / solder / shrink wrap / soldering gun, etc. for wiring
INSTRUCTIONS
PRINTABLES:
Print the lid (ironing setting) and main at 5% infill to keep it lightweight. The lid will need supports. Print the fan grille and battery shield at 15% infill.
ELECTRONICS & ASSEMBLY
Clip the tabs off the sides of the rocker switch, place in the hole and hot glue into place. Place the the fan* and assemble / wire / solder everything. Use the battery shield to protect the 9v by placing in the lid (stays put by friction). Tie rubber bands (or elastic strings) through the holes and place the frozen baggie in the holder. Use small zip ties (in the holes at the sides) to keep the lid on. Secure to the cat carrier with wire or zip ties (the holes at the bottom).
Battery_Shield.stl | 1.3KB | |
Cat_Aircon_LID_9v.stl | 307.6KB | |
Cat_Aircon_MAIN.stl | 196.2KB | |
Fan_GRILLE.stl | 477.9KB |