This is version 2 of my case for the little transmitter I co-developed with Harry over at ZachTek. The little button knobs are optional if your printer can handle the small square hole. The buttons can be clicked through the holes without the knobs. They just make it look nicer.
It should be a straightforward print. I'd suggest 0.2 mm or less layer height.
You will need four M3 by 8 mm screws.
| Back_Panel.stl | 63.9KB | |
| Case_bottom.stl | 318.4KB | |
| Case_top.stl | 458.9KB | |
| Dual_button.stl | 53.0KB | |
| Front_Panel.stl | 163.0KB | |
| Single_button.stl | 31.5KB |
