Caribou & Zaribo Y-Axis Linear Rails 15×15 3D Printer Model
The file 'Caribou & Zaribo Y-Axis Linear Rails 15×15 3D Printer Model' is (stl,amf) file type, size is 2.7MB.
The file 'Caribou & Zaribo Y-Axis Linear Rails 15×15 3D Printer Model' is (stl,amf) file type, size is 2.7MB.
This is a modification of the original Zaribo (or Caribou) Y-Axis (https://github.com/Zaribo/Zaribo-MK3) to replace the Misumi bearings by linear rails of 15x15 size. I have used the next rails and blocks:
2 x HGR15RH rails (length must be 354mm)
I have used only two blocks instead three because they are too big and they don't fit on the left rail, a special adaptor has been designed.
The Motor Holder an Y-Tensioner must be changed by the ones I have included here because the carriage is 10mm higher, so I have increased the heigth of these pieces by 10mm.
WARNING: The use of this modification implies loosing 10mm height, because the size of the blocks. So the firmware must be modified by 10mm less (310mm for a Zaribo 320) for Z calibration to work.
Additional Hardware:
Carriage:
Y-Tensioner:
Y-Motor Holder:
Updates:
2019/07/17:
Added a new adapted Y-Tensioner modified from the one released by Vekoj (https://www.thingiverse.com/thing:3595521)
2019/08/20:
Minor fix: corrected the distance between holes to attach the heatbed, it was 21mm and must be 20mm
| Left_Rail_HGH15CA.stl | 725.7KB | |
| Left_Rail_HGH15CA.zip.amf | 161.6KB | |
| Right_Rail_HGH15CA.stl | 819.7KB | |
| y-BeltHolder_MK3-1x.stl | 870.4KB | |
| Y-Motor_Holder_Support_v1.stl | 388.2KB | |
| Y-Motor_Holder_v1.stl | 1.9MB | |
| Y-Rail_Holder_LR15_Bottom.stl | 366.9KB | |
| Y-Rail_Holder_LR15_Top.stl | 1019.3KB | |
| Y-Tensioner-Base_2.1+10mm.stl | 253.3KB | |
| Y-Tensioner-Idler_2.12_16T_ID3_Screw_Version-Juan.stl | 308.0KB | |
| Y-Tensioner_Frame.stl | 718.4KB | |
| Y_Tensioner_Pulley.stl | 764.2KB |
