Cardboard Spool Adapter For Mini Spools 150mm, 250g (Eryone And Others) 3D Printer Model
The file 'Cardboard Spool Adapter For Mini Spools 150mm, 250g (Eryone And Others) 3D Printer Model' is (stl) file type, size is 37.7KB.
The file 'Cardboard Spool Adapter For Mini Spools 150mm, 250g (Eryone And Others) 3D Printer Model' is (stl) file type, size is 37.7KB.
This is a remix of a model from printables.com
https://www.printables.com/model/251028-cardboard-spool-ring-for-bambu-lab-ams-parametric
This model has been edited to fit small mini cardboard spools. Like the Eryone 250g rolls and other brands. So far all of the mini cardboard spools I have encountered have all been the same outer diameter but I can't guarantee this so check your specific spool,. Cardboard spools don't like to roll well on bottom rollers.
*I am relatively new to designing and I was unable to figure out how to keep the outer side of this ring from partially blocking the filament holes without making the design rather weak. However, you can still access the holes but they are just smaller, which actually might be a benefit as the filament stays in them better. Also the spool is cardboard, so you could easily make the holes larger if you wanted.
This is a thin print so make sure your bed is clean or it will pull up. Otherwise you can use a brim but I was able to print it fine without a brim.
You can resize this a bit if needed. It will upscale just fine, but if you want to shrink, I recommend keeping the Z at 100% and only shrinking the x and y axis.
| cardboard_spool_ringSmall150_v1.stl | 142.0KB |
