The file 'Card Storage – Stackable & Low Filament Use (Flesh & Blood, Pokémon, Magic, Yu-Gi-Yo, TCG, …) 3D Printer Model' is (stl) file type, size is 26.5KB.
We needed a card storage system that was stackable with dividers and that didn't go overboard in filament use (for our case it was to store Flesh & Blood and Pokémon cards).
It needed to be fast in use as well, so a fully closed box would not do (not to mention the filament use of a closed box :D)
All card storage models that I found were not stackable or they used way to much filament. In fact I started with a remix, but eventually I started from scratch since I wanted to change everything :)
Printing this should be around 53 gram of filament use if you use 5% infill, which is fine for our storage needs. Increase is needed.
When using a couple of them, it looks like a castle wall. This was not my intent, but I like how it looks :)
I printed this on an Creality K1 (Max) without any problems, but any printer should be fine.
| card-storage_divider.stl | 8.9KB | |
| card-storage_stackable.stl | 132.3KB |
