Card Box With Replaceable Inserts 3D Printer Model
The file 'Card Box With Replaceable Inserts 3D Printer Model' is (stl) file type, size is 523.3KB.
The file 'Card Box With Replaceable Inserts 3D Printer Model' is (stl) file type, size is 523.3KB.
These are large storage boxes that are sized for cards in hard sleeves. The smaller box can be used as a deck box if desired.
The lids fit tight to make sure they don't pop open. The small box hinge holes can be trimmed if the lid does not snap in. The large box lid should have just enough flex to bend it to get the pins in the holes.
Both boxes should be printed on the bottom to avoid the need for supports. The inserts should be printed with the logos facing upwards, and the divider printed on either flat face.
| BIG_Card_Box_Bottom.stl | 107.9KB | |
| BIG_Card_Box_Lid.stl | 87.0KB | |
| Blank_Front_Insert.stl | 1.4KB | |
| Card_Box_Bottom.stl | 34.7KB | |
| Card_Box_Lid.stl | 87.0KB | |
| Card_Divider.stl | 67.5KB | |
| FFTCG_Insert.stl | 145.0KB | |
| MTG_Insert.stl | 408.5KB | |
| Pokemon_Insert.stl | 878.1KB | |
| YuGiOh_Insert.stl | 361.4KB |
