Captain America Shield Magnet 3D Printer Model
The file 'Captain America Shield Magnet 3D Printer Model' is (stl) file type, size is 74.0KB.
The file 'Captain America Shield Magnet 3D Printer Model' is (stl) file type, size is 74.0KB.
I wanted a Captain America shield magnet to go with the Mjolnir magnet I made for the fridge. I liked the design by ChaosCoreTech, however I wanted a sideways "stuck" look.
To achieve this I reduced the size of the shield from 80mm to 68mm and added a curve to the backside. I removed a section to create a flat side with a 60 degree angle and added a lip on the edge to make room to insert the magnet. I added a hole on the flat side to accommodate a round 6mm x 3mm magnet.
This shield prints best with the flat side on the bed and does not require any supports.
| shield_magnet.stl | 168.0KB |
