I wanted some caliper holders that would allow the calipers to be hung with the nose perpendicular to the pegboard. I found some that did this, one for Ikea pegboard, other for multiple calipers. But they all would need to be printed in one piece with the pegs. The wonderful Pegboard Hook system by Reeseallen was designed so the pegs were printed horizontally and thus could be much stronger than vertically printed pegs which suffered from layer adhesion weakness.
So here comes this remix, which also includes two other holders I designed, for roll of tape and for a compressed air(or any other) can.
All you do is print as many Pegboard-V-Multi support.stl files as the number of holders you intend on using. (I found the vast array of files in Reeseallen's pegboard hook system a little intimidating have also included the only piece from the pegboard hook system that you need to attach these to the pegboard.) Then print the holders you want. The two parts snap together and can then be attached to the pegboard.
| Caliper_pegboard_mount.stl | 30.5KB | |
| Can_holder_70mm.stl | 61.5KB | |
| Pegboard-V-Multi_support.STL | 118.6KB | |
| Tape_roll_holder_20mmx77mm.stl | 24.7KB |
