I love the caffeine molecule coaster and decided to rework it a bit so I could print it as a two color, single piece print, by pausing and switching filament. (twice) I also increased the width of the letter groove by .4mm to make the letters a little more bold. Last, even though I love the look and feel of the rounded edge and was planning to keep that feature on mine, I found that due to (insert long story here) I couldn't pick it up off the table. I needed to use a square edge so I could pick it up.
The top and bottom close-up photos were not needed, I just liked the way they looked. Printed using concentric fill pattern for the top and bottom layers.
| coaster3_round_edge.stl | 1.9MB | |
| coaster3_square_edge.stl | 1.1MB |
