This is a remixed design of CadetPedals ( Vince_Prints)
The original is here: https://www.thingiverse.com/thing:4655002
F-16 pedal from here: https://www.thingiverse.com/thing:4661690
My changes:
-More bearings on the axis with M8 bolts directly with M8 nuts.
-The stopper for the pedals is on the bar (not on the gears).
-Pedals connections with 2 bolts M8x80 on bearings.
-Instead of M3 Threaded Inserts, I use M4 self-tupping screws for plastic directly.
-Added dust covers.
-Arduino code Brakes changed to a separate axis in Win calibration.
-STEP attached.
REQUIRED:
Bearings 608 qty: x17
M8x40 Socket Screw qty: x6
M8x80 Bolts qty: x2
M8 Flat washer qty: x4
M8 Lock Nut qty: x10
M4x20 self-tupping screws for plastic qty: x16
M4x20 Socket Screw qty: x1
M4x16 Socket Screw qty: x1
M4 Lock Nut qty: x2
M4 Flat washer qty: x2
M3 self-tupping screws for plastic qty: x4
M3x6 Socket Screw qty: x4
M3 Nut qty: x4
Potentiometer 3Pin (B10K) qty: x3
ARDUINO PRO MICRO (ATmega32U4 5V/16MHz ) qty: x1
I used Tensile Springs - Wire0.6mm, L:30mm, OD6mm qty: x3 (but I think a little bit stronger springs would be better)
| Bar_Back.stl | 218.1KB | |
| Bar_Front.stl | 303.8KB | |
| Bar_Left.stl | 542.2KB | |
| Bar_Right.stl | 542.2KB | |
| Base-.stl | 858.9KB | |
| Bearing_Bushing.stl | 110.8KB | |
| CadetPedals-F16.ino | 953.0B | |
| Cadet_Pedals_F-16.stp | 13.9MB | |
| Cover_x2.stl | 123.4KB | |
| Gear_A_X2.stl | 452.1KB | |
| Gear_B_x2.stl | 420.0KB | |
| Gear_Rudder.stl | 176.7KB | |
| Pedal_Left.stl | 4.9MB | |
| Pedal_Right.stl | 4.9MB | |
| Platform_Center.stl | 493.1KB | |
| Platform_Heel.stl | 185.5KB | |
| Platform_Left.stl | 113.9KB | |
| Platform_Right.stl | 114.2KB | |
| Tension_Arm.stl | 93.1KB |
