Cable Organizer/ Holder Collection 3D Printer Model
The file 'Cable Organizer/ Holder Collection 3D Printer Model' is (stl) file type, size is 5.7MB.
The file 'Cable Organizer/ Holder Collection 3D Printer Model' is (stl) file type, size is 5.7MB.
Heyho
Here you have a collection of Holder to tame your Cable jumble :D I got inspired by different Solutions like peaberry´s Cable Tie Base.
I Printed mine with ASA, 0,2 mm layer Height, 0,6 mm Nozzle, 100% infill, 2-3 Perimeter.
Holder Selection:
Single, I, T, + Holder (3 mm Screw)
Width for the cable tie: 4,8 mm
Pyramid + Screw (S = 3 mm, M = 3,5 mm, L = 4 mm)
Width for the cable:
S = 4,15 mm
M =4,84 mm
L = 5,3 mm
Pyramid + Double Sided Tape (Fast & Cheap print, less strength)
Width for the cable:
S = 3,48 mm
M = 4 mm
L = 5,2 mm
I tested all Pyramid (S) and normal Versions to compare its strength.
No wonder: The screwed ones are far stronger. Only the Pyramid (s) got destroyed during the test with a crowbar :) With all other models or if layed through 2 loops of the pyramid, the holder survived the test and instead the cable ties broke.
The holder got only a small visible deformation after the cable ties broke.
Installation tipps:
a) You can use the holder in different ways. Eather to crowd 4 cable ties into the pyramid or Plus Holder or use 1-2 Cables and increase the strength of the holder this way.
b) You can scale the holder up/ down if you need special sizes.
c) Do not overtighten the screws. I used a torque around 5 Nm and it worked just fine.
Have fun and keep printin! :)
| Cable_Tie_Holder_Pyramid_L.stl | 1.7MB | |
| Cable_Tie_Holder_Pyramid_M.stl | 1.6MB | |
| Cable_Tie_Holder_Pyramid_S.stl | 1.5MB | |
| Cable_Tie_Holder_Pyramid_Tape_L.stl | 1.6MB | |
| Cable_Tie_Holder_Pyramid_Tape_M.stl | 1.3MB | |
| Cable_Tie_Holder_Pyramid_Tape_S.stl | 1.2MB | |
| Cable_Tie__Holder_I.stl | 829.3KB | |
| Cable_Tie__Holder_Plus.stl | 1.6MB | |
| Cable_Tie__Holder_Single.stl | 520.9KB | |
| Cable_Tie__Holder_T.stl | 1.2MB |
