Cable Hook 3D Printer Model
The file 'Cable Hook 3D Printer Model' is (stl) file type, size is 267.7KB.
The file 'Cable Hook 3D Printer Model' is (stl) file type, size is 267.7KB.
A cable/ coax hook to keep your coaxes off the floor and out the draws.
Also a hat etc
I made mine from ABS and its quite strong.
I like the shiny look, so acetone vapour smoothing is the go.
to get a even finish bottom to top I use heat for 4sec to vaporise the acetone. The glass plate on top is to visually see when the vapour reaches the top. The acetone is heaveir than air so the vapour will sit in the bowl with the glass removed after heating.
DONT SWITCH ON THE BURNER AGAIN ONCE THE GLASS GETS WET OR YOUR ASKING FOR TROUBLE.
Remember acetone is very flammable
Drill holes to suit the screws your using.
| Hat_hook.stl | 1.3MB |
