A set of Combs for Cables and AIO water coolers.
I bought a set on Amazon and didn't like them much, so I bought a 3D printer so I could make them myself.
With the stock PLA filament I got with my ender 3, these combs were more durable, lower profile and didn't show the seam of an injection mold.
Faces are fileted to prevent the edges from biting and damaging cables.
The AIO combs come in an array of sizes, measured from the centers of each water tube.
The tubes are closer together on the pump than the radiator so I used 1 of each size from 10-35mm.
The AIO combs were tested fit a Cooler Master ML240 v2
Cable Combs were tested and fit Phanteks cables and Corsair cables.
*Fit may vary with print settings, material expansion, etc...
Cable combs were procedurally generated and may appear stitched at many locations when viewing the model with transparency. This should not affect slicing if you are using Cura. Other slicers have not been tested.
| AIOComb_10mm.stl | 2.4MB | |
| AIOComb_15mm.stl | 2.1MB | |
| AIOComb_20mm.stl | 2.0MB | |
| AIOComb_25mm.stl | 2.0MB | |
| AIOComb_30mm.stl | 1.7MB | |
| AIOComb_35mm.stl | 1.7MB | |
| AIOComb_40mm.stl | 1.6MB | |
| AIOComb_45mm.stl | 1.4MB | |
| AIOComb_50mm.stl | 1.4MB | |
| Comb_1x10.stl | 6.5MB | |
| Comb_1x11.stl | 6.5MB | |
| Comb_1x12.stl | 7.1MB | |
| Comb_1x2.stl | 2.9MB | |
| Comb_1x3.stl | 4.3MB | |
| Comb_1x4.stl | 4.8MB | |
| Comb_1x5.stl | 5.5MB | |
| Comb_1x6.stl | 5.6MB | |
| Comb_1x7.stl | 5.5MB | |
| Comb_1x8.stl | 5.5MB | |
| Comb_1x9.stl | 6.1MB | |
| Comb_2x1.stl | 3.1MB | |
| Comb_2x10.stl | 7.7MB | |
| Comb_2x11.stl | 8.4MB | |
| Comb_2x12.stl | 9.1MB | |
| Comb_2x2.stl | 4.1MB | |
| Comb_2x3.stl | 5.0MB | |
| Comb_2x4.stl | 5.8MB | |
| Comb_2x5.stl | 6.1MB | |
| Comb_2x6.stl | 6.6MB | |
| Comb_2x7.stl | 6.8MB | |
| Comb_2x8.stl | 7.0MB | |
| Comb_2x9.stl | 7.9MB |
