C74 Roof Rack Sytem 3D Printer Model
The file 'C74 Roof Rack Sytem 3D Printer Model' is (stl) file type, size is 226.1KB.
The file 'C74 Roof Rack Sytem 3D Printer Model' is (stl) file type, size is 226.1KB.
Custom Roof Rack system for the WPL C74!
This roof rack is designed to clamp onto the rain gutter that runs along the sides of the body no glue needed though this does use a LOT of m2.5 screws but so far I've not been able to break this setup off the top of the vehicle an it can be easily removed an re-adjusted and changed up
you will need (this is the maximum amount if you want the full sized roof covering but doesn't hurt to have spares!)
(27) m2x4mm screws for the base model
(6) m2x6mm screws for mounting the basket to the LONG clamps
(4) m2x6mm screws for attaching the light buckets to the basket that has the mounts
| center_rib.stl | 68.8KB | |
| light_bucket.stl | 224.8KB | |
| light_bucket_cover.stl | 58.6KB | |
| long_basket.stl | 147.7KB | |
| long_basket_w_light_mounts.stl | 178.5KB | |
| Long_plank.stl | 68.4KB | |
| Short_Plank.stl | 48.5KB | |
| small_clamp.stl | 25.8KB | |
| tall_clamp.stl | 68.0KB |
