This costume accessory will be used with the Butterfly Fairy Wand (http://www.thingiverse.com/thing:1775518) so as to create the perfect ButteryFly Fairy (or any other Fairy costume). I have used many pieces from many authors. I rebuilt the dots on the antennas from scratch and replaced every black part except the ear frames and the antenna on the frames.
In order to print it you will need use a dual printer such as the Replicator Dual and overlay them.
First Load the Yellow Front frame then load the black front frame with the following offsets:
Z offset of 11.80 mm
X offset: Center the two together (0 offset)
Y Offset: .7 mm
For the Left Ear piece:
First Load the Black Left Ear piece and then load the Yellow Left Ear piece with the following offsets:
Z offset of 5.48 mm
X offset: 3.6 mm
Y Offset: 39.1 mm
For the Right Ear piece:
First Load the Black Right Ear piece and then load the Yellow Right Ear piece with the following offsets:
Z offset of 5.48 mm
X offset: 3.6 mm
Y Offset: 39.1 mm
The sources for this creation are as follows:
The frames: http://www.123dapp.com/smb-123D_Design/Butterfly-Sunglasses/1256889
The Ear piece Butterfly: https://www.tinkercad.com/things/8T36BUO8uTr-wing
| black_parts_for_front_frame_of_butterfly_glasses.stl | 1.5MB | |
| left_ear_black_piece_of_frame_butterfly_fairy_glasses.stl | 139.6KB | |
| left_ear_yellow_piece_of_frame_butterfly_fairy_glasses.stl | 270.6KB | |
| right_ear_black_piece_of_frame_butterfly_fairy_glasses.stl | 139.6KB | |
| right_ear_yellow_piece_of_frame_butterfly_fairy_glasses.stl | 270.6KB | |
| yellow_piece_of_frame_butterfly_fairy_glasses.stl | 548.1KB |
