Quick modification of the standard head.
Bunny head + 'bunny tail'
and
Cat head + cat tail
and
a connector for either of the tails
Print the heads face down.
The inside of the ears will be a bit scruffy, but that's fine.
You might need a raft for the cat-tail. Not a lot of flat surface there.
The tail connector is best printed standing up with supports and a brim.
| bunny-head.stl | 166.5KB | |
| bunny-tail.stl | 141.8KB | |
| cat-head.stl | 139.8KB | |
| cat-tail.stl | 443.8KB | |
| tail-connector.stl | 464.5KB |
