The design layout is inspired by DJRobin's design.

I really like the layout done by DJRobin, hence I redesigned it to suit my coin capsule token instead of wooden tokens. I also realise the dimension of my box seems to be different from DJRobin's, and my cards does not have the height clearance to keep it perpendicular to the box unlike the ones in his design. Also, his Heroine Boards seem to be made of cardboard too, whereas mine are plastic cards.

I like my components to be tidy with minimum rattle when kept, and also easy to take and return what I need. Hence I included a cutout for the Heroine/Sight/Action/Intensity boards so that it's easier to dig them out, and the Heroine Pattern card tray have dividers for each Heroine for the convenience searching your Pattern cards. The dividers are slightly angled such that the cards can lay at an angle which allows the box to fully close, and at the same time, visually helps to search for your Heroine Pattern cards.

The ability tiles tray are segregated (Team Action Tiles and Power Up Tiles). I added a wall in the middle so it's easier to grab the tray out of the box. A "blank tray" with no particular component storage purpose were placed underneath so it's leveled with everything else (Similar to DJRobin's).

Bullet token tray were designed with one of the rows dedicated for the AP, Intensity, Shield, Crosshair and Mariel marker for convenience.

This organiser can fit Bullet Heart & Orange. The Pattern card tray can fit both boss and heroine pattern cards (see picture 5 onwards), but it's a very tight fit and I wouldn't recommend it. I used this customizable card boxes to make a quick storage card box for the Boss Pattern cards and it can be placed on the Sight/Heroine/Action Tray. I have uploaded the boss storage tray here but it can ideally be shortern by a few millimeters as it has some minor protrusion when placed mine on the Board Tray, but not significant.

TLDR + additional things to note:

• My box internal dimension is measured around ~ 282mm x 282mm x 61mm.
• This organiser/insert can fit Bullet Heart + Orange expansion.
• Boss tray is not necessary as they can all fit in the pattern tray with sleeves, but it's not recommended as it will be a very tight fit. However if you only have bullet heart, or without sleeves, it might be feasible.
• The Pattern tray divider have overhang on the hook, but I did not use support as they have fragile joints and may snap when clearing the support. May need to use sandpaper on the hook to fit in the tray properly.

Designed with Tinkercad.