Bulbasaur Coin Bank 3D Printer Model
The file 'Bulbasaur Coin Bank 3D Printer Model' is (stl) file type, size is 19.99 KB.
The file 'Bulbasaur Coin Bank 3D Printer Model' is (stl) file type, size is 19.99 KB.
A "piggy" bank version of the low-poly Bulbasaur. I hollowed out FLOWALISTIK's model and added a coin slot on top and a hole on the bottom for dumping the coins out. The second file is for a flat plug to fit in the hole. It should snap in and pry out easily, but there's a small slot on the edge of the opening where you can insert something to help pry it out if it gets stuck.
This little guy should hold a good amount of change. I actually didn't have enough change on hand to fill him up!
You can position the plug to print between his front paws/under his chin, since the design doesn't require any supports there and it will print cleanly.
| bulbasaur_bank.stl |
| plug.stl |
