Buddy Heater Propane Hose Hood Outlet (camper Van) 3D Printer Model
The file 'Buddy Heater Propane Hose Hood Outlet (camper Van) 3D Printer Model' is (stl) file type, size is 389.0KB.
The file 'Buddy Heater Propane Hose Hood Outlet (camper Van) 3D Printer Model' is (stl) file type, size is 389.0KB.
This is used to pipe a small propane hose of 1.5" or less into your camper van so you can run a buddy heater. You need to install a propane bottle mount on the outside of your van. So you don't explode! Then run the hose inside to the heater. This thing I designed stops rain from entering your van while piping the hose inside. The hardware is for M4 screws and nuts. The propane hose hood captivates the nuts for easy install. Use butyl tape and caulking to install it under and around the screws. Works good! I used PLA+ for extra rigidity. Won't snap easy like normal PLA. love this stuff.
Use some TPU and design yourself a nice grommet to fit your hole and hose then place my propane hood over it and you are all set.
Enjoy!
-Casey
| propane_outlet.stl | 1.1MB |
