Broom And Dustpan 3D Printer Model
The file 'Broom And Dustpan 3D Printer Model' is (stl) file type, size is 2.0MB.
The file 'Broom And Dustpan 3D Printer Model' is (stl) file type, size is 2.0MB.
Broom and dustpan set for all your tiny cleaning needs. Lower your initial layer line width if the bristles aren't all slicing - on my bambu a1 I take it from .5 to .45.
Bristles have a little pull tab to make them MUCH easier to pull off the bed. Print about 12 of these little things, then cut off the tabs and glue into the broom.
The sticks are the same size as the ones in the tiny desktop gardening set I designed - this was along the same ideas but the gardening set was getting big. It's kind of related though, if you're gardening, sometimes dirt falls out. The stick with additional bed adhesion has a layer at the end that you can pull off after printing.
| bristles.stl | 109.7KB | |
| broom_base.stl | 969.9KB | |
| broom_cover.stl | 152.4KB | |
| broom_stick.stl | 763.8KB | |
| broom_stick_adhesion.stl | 833.1KB | |
| dustpan_large.stl | 976.5KB | |
| dustpan_small.stl | 833.8KB | |
| grip_end.stl | 993.8KB |
