Brewery 2/3 – Brewhouse (z-scale) 3D Printer Model
The file 'Brewery 2/3 – Brewhouse (z-scale) 3D Printer Model' is (stl) file type, size is 85.46 KB.
The file 'Brewery 2/3 – Brewhouse (z-scale) 3D Printer Model' is (stl) file type, size is 85.46 KB.
Brewery 2/3 - brewhouse (z-scale)
Combine with Brewery 1/3 and 3/3 to a a small town brewery.
Assembling:
Use transparent foil, cut to fit and glued on the inside of the wall elements, as glass in the windows. Be careful not to place the foils in areas where the walls connect!
Use for the windows of the brewhouse clear foil to allow the kettles to be seen inside.
I use 0,5mm transparent foil, clear or slightly opaque, availably at stationary shops.
Alternatively you can "upcycle" plastic packaging material from your groceries.
Paint to your taste and assemble as seen in the picture.
Place the chimney to the side of the building.
Printing:
Print the wall elements flat on the printing bed to allow the details printed without/few supports.
Print base plates, interior, brew kettles, chimney, silo body (3x) and roof with the lower side in the printing bed.
Print the silo foot (3x) upside down
Mirror the elements in your printer software in case you need it in another orientation.
For n-scale use a scaling factor of 1,38 in your printer software.
| t084a_base_plate_building.stl |
| t084b_front_wall_1.stl |
| t084c_side_wall_1.stl |
| t084d_roof_1.stl |
| t084e_interior_brew_house.stl |
| t084f_lower_brew_kettle.stl |
| t084g_upper_brew_kettle.stl |
| t084h_front_wall_2.stl |
| t084i_rear_wall_2.stl |
| t084j_roof_2.stl |
| t084k_base_plate_silos.stl |
| t084l_chimney.stl |
| t084m_silo_foot.stl |
| t084n_silo_body.stl |
