The original leg / cranks were too small to print in PLA, and were causing the edges of the hex section to round off upon cranking. I remodeled a few pieces to accommodate a double sized crank
I also reduced the size of the pins by about 50 microns, just enough to have a loose fit so the joints don't need wearing in, these ones move more freely.
| BEAM_v3.STL | 91.1KB | |
| CRANK_ARM_v3.STL | 23.3KB | |
| CRANK_SHAFT_FAN_ADAPTER_v3.STL | 30.9KB | |
| CRANK_SHAFT_v3.STL | 23.3KB | |
| END_BEAM_v3.STL | 71.2KB | |
| INNER_LINK_v3.STL | 54.2KB | |
| PLATE_LEG_SECTION_v3.STL | 1.2MB | |
| UPPER_LINK_v3.STL | 65.2KB |
